Saturday, December 6, 2014

Questions and Answers




Questions by 4122 Fourth year student 


Q1. How can I distinguish CLINICALLY between affected and infected dentin in deep excavations?

Answer:
 You have to observe the degree of discoloration (extrinsic stain)  and test the area for hardness by the feel of an explorer tine .
Sometimes the discoloration is slight and gradually changeable (in acute caries) and the hardness felt by the hand through an instrument may be an inexact guide, In this case  we can  use caries- staining products (a 1% acid red 52 solution for 10 seconds).

Q2. Should I remove all discolorations ?

Answer: 
In chronic (slow) caries , infected dentin  usually is discolored,and  the bacterial front is close to the discoloration front, therefore  all discolored dentin should be removed unless judged to be within 0.5mm of the pulp.

In acute(rapid) caries, the discoloration is slight, and the bacterial front is well behind the discoloration front, some discolored dentin may be left , although any remarkable discoloration should be removed.

procedure:

Start by removing the area of darker stain,and when working in the more lightly stained area ,use a spoon excavator to check for firmness: where it is firm ,protein matrix and tooth structure should not be removed,Hence all stains lighter than this should be left in place.


Art and science  of operative dentistry fifth edition chapter 9



Monday, December 1, 2014

A Video for preclinical students: Amalgam carving




  •          Read the previous post



  •        Amalgam test: the ideal time to start carving(use a carver or a probe to test the plasticity   of amalgam)





  •            Start carving,use the cuspal incline as guidance.




 

  •         Carving.





  •       Post carve burnishing with a football burnisher :use cusp incline as guidance and  place the tip of the burnisher on fissures.




  •            The final shape.






Saturday, November 29, 2014

Tips for preclinical students to success in amalgam restoration



1: Understand  the Amalgam procedure steps.


2: Read and understand the tooth anatomy.


3: Use proper instruments.

 


4: Apply pressure when Condensing Amalgam.

 


 5: Use a round burnisher for Pre-carve burnishing.

 


 6: Start Carving.


Right time: Start carving when the dental amalgam shows some resistance to the carving instrument (Use explorer to test the amalgam  resistance to the carving instrument) Amalgam shouldn't be too plastic or too set.
 


7: Start with gross carving.



8: While doing the gross carving keep measurements 1mm greater than what is needed.
This 1mm will be used in fine carving and finishing. 


9: Keep  the carver parallel to the marginal ridge.


10: Use the cuspal incline as guidance.

11: After doing the gross carving, go for the fine carving for producing the details.


12: When carving the fossa, keep the blade of the carving instrument angled in "harmony" with the slop of the cusp. 


13: Remove flash.

14: Use a  football burnisher for post-carve burnishing : The tip of the instrument should be placed on fissures.

Restoration completed!

Watch the video  (next post)


Evaluate yourself 

Amalgam restoration (Cl I cavity prep)



Feature
Surface quality
Margins
Occlusal anatomy

Proper
Status
Smooth
No
porosity
No excess
Undetectable
to sharp
explorer
No ditch
-No under carv
-No over carv
Reproducing the occlusal anatomy
In harmony with tooth structures.